Shandong Retu International Trade Co., Ltd.

The tabletop of a woodworking engraving machine is the panel that supports the engraved materials. After long - term engraving, the tabletop may become uneven, which can easily lead to non - standard engraved items, with more burrs, prominent on the engraved texture lines, and varying in depth, having a relatively large impact. Therefore, it is necessary to replace the tabletop within a certain period to ensure quality. The tabletop of a woodworking engraving machine can be replaced according to the following methods.

1. Pry open the damaged tabletop of the woodworking engraving machine with a thin - sheet metal tool, such as a painter's scraper. The thin - sheet metal can be easily inserted into the gap between the tabletop and the tabletop panel. Pry it gently, as excessive force may cause the screws of the tabletop platform to loosen, resulting in an uneven and shaky tabletop chassis, and damaging the horizontal balance of the chassis.

2. After removing the damaged panel, scrape off the original glue adhered to it. You can dilute it with banana water or a cleaning agent, which makes it easier to fall off and more convenient and effective to clean.

3. Apply glue, such as strong adhesive, to the reverse side of the newly cut panel. Double - sided tape can also be used, but strong adhesive is more secure. Double - sided tape is easier to remove when replacing the panel next time. It depends on how much you engrave. If you engrave a lot and the replacement interval is short, use double - sided tape.

4. After replacing the tabletop, it may not be balanced. You must use the engraving system, install a large cutting tool, control the spacing, and mill off a thin layer. In this way, the tabletop panel will be standardized.

How to Replace the Tabletop of a Woodworking Engraving Machine?

分享至微信分享

分享至微信